CONTACT US

Our Address

Science Avenue, High-tech Zone, Zhengzhou City, Henan Province, China

  • Effects of foundry sand as a fine aggregate in concrete ...

    Cited by: 63
  • Effects of foundry sand as a fine aggregate in concrete ...

    Cited by: 63
  • Application of Foundry Waste Sand In Manufacture of

    2017-8-28  foundry sand has beneficial applications to other industries. Foundry sand consists primarily of silica sand, coated with a thin film of burnt carbon, residual binder (bentonite, sea coal, resins) and dust. Foundry sand can be used in concrete to improve its strength and other durability factors.

  • Mechanical and Durability Properties of Concrete

    3.2. Mechanical Properties 3.2.1. Compressive Strength. The compressive strength of all mixtures was obtained at ages of 7, 28, 90, and 180 days, and the values are summarized in Table 4 and presented in Figure 4.The main objective of this research is to utilize FS as a substitute material in concrete production and not to enhance the strength properties of the concrete.

  • Behaviour of Concrete Made by Partially Replacing Fine ...

    2018-4-28  The incorporation of waste foundry sand and quarry dust causes systematic decrease in workability due to the presence of very fine binders. Concrete acquires comparable compressive strength with the control mix for mix M1 containing 50% manufactured sand, 35% waste foundry sand and 15% quarry dust.

  • (PDF) Stone Dust in Concrete: Effect on Compressive

    Stone dust is a waste material obtained from crusher plants. It has potential to be used as partial replacement of natural river sand in concrete.

  • Can waste foundry sand fully replace structural

    Foundry sand (FS) waste creates a serious solid waste management problem worldwide due to the high volumes produced, necessitating alternatives to landfilling. A possible route is its use in concrete; however, the current consensus is that FS can only be used for modest sand replacements, based mostly on evidence on concrete with clay-bound FS (greensand).

  • Study on Compressive Strength of Quarry Dust as Fine ...

    The concept of replacement of natural fine aggregate by quarry dust which is highlighted in the study could boost the consumption of quarry dust generated from quarries. By replacement of quarry dust, the requirement of land fill area can be reduced and can also solve the problem of natural sand scarcity. The availability of sand at low cost as a fine aggregate in concrete is not suitable and ...

  • USE OF QUARRY DUST IN CONCRETE AS REPLACEMENT

    2018-10-3  Foundry sand is high quality silica sand this sand is generally used in foundry casting processes. The sand is bonded to form moulds or patterns used for ferrous (iron and steel) and non-ferrous (copper, aluminium, brass) metal ... replaced by quarry dust because strength of concrete is affected by this process. In other process if we mix quarry

  • Use of Quarry Dust to Replace Sand in Concrete – An ...

    2017-3-30  Due to increase in temperature the strength of concrete was affected. To find the loss in strength the concrete cubes were kept at 100oC at an age of 28 days for 24 hrs in an oven and then tested in CTM. The strength obtained is presented in Table 4. Table 4: Mean Compressive strength of concrete at 100oC Fine aggregate Sand: Quarry dust 28 days

  • EXPERIMENTAL INVESTIGATION ON THE STRENGTH

    2019-4-9  Type of foundry sand depends on the casting process in foundries. Foundry sand is generally of two types: Green sand, chemically bounded sand. Additive in sand depends on type of metal casting. Use of waste foundry sand as full or partial replacement by fine aggregate helps to achieve different properties or behavior of concrete.

  • high strength concrete with foundry sand - Sians

    Review Utilization of Waste Foundry Sand and Granite . strength may increase with replacement of WFS up to 20-30% and for G S up to 15-20% Keywords— Concrete Waste Foundry Sand Granite Slurry Compressive Strength Eco-Friendly I INTRODUCTION Concrete is the backbone of all the construction and development activities around the world being the most extensively used construction material [1]

  • To Examine the Strength Characteristics of Concrete with ...

    2017-3-26  It was found that split tensile strength of concrete incorporating foundry sand (using 15 %, 30 %, 45 % and 60 % replacement levels with fine aggregate and a w/c of 0.44) depended on the percentage of foundry sand used The variation of split tensile strength was shown in Table 4.2.

  • Utilization of Foundry Sand: An Art to Replace Fine Sand ...

    2016-4-1  resins) dust. Foundry sand can be used in concrete to make better its strength and other durability factors. Foundry Sand can be utilize as a partial replacement of cement or as a partial replacement of fine aggregates or total replacement of fine aggregate and as supplementary addition to achieve different properties of concrete.

  • A Technical Review on Quarry Dust and Foundry Sand

    2015-1-30  noticed fresh concrete behavior with foundry sand that workability is decreases with the increase of foundry sand content by slump test. Most of the researchers noticed positive changes in the concrete containing foundry sand and concrete containing quarry stone dust in terms of compressive strength and tensile strength.

  • use of recycled foundry sand in concrete

    Use of Recycled Foundry Sand in the Cleveland Area. the uses of recycled foundry sand in the Cleveland, Ohio area. The review was coordinated by Mr. Joe Alexander, Project Sales Manager, for Kurtz Bros. Kurtz Bros. is a materials broker that collects used foundry sand from various foundries and transports the material to projects where fill material is needed.

  • To Study the Effect on Mechanical Behavior of Concrete ...

    2019-2-15  foundry sand in high-strength concrete production. The natural fine sand is replaced with waste foundry sand (0%, 5%, 0%, and 15%). The modulus of elasticity is also calculated according to the equation suggested by the ACI 318 at the age of 28 and 56 days, as follows: E= 0.043 x W3/2

  • Use of spent foundry sand and fly ash for the

    In the United States alone, the foundry industry discards up to 10 million tons of sand each year, offering up a plentiful potential resource to replace sand in concrete products. However, because the use of spent foundry sand (SFS) is currently very limited in the concrete industry, this study investigates whether SFS can successfully be used as a sand replacement material in cost-effective ...

  • Effect of Waste Foundry Sand (WFS) on the Mechanical ...

    2019-7-1  foundry sand. (3) Split tensile strength decrease on increase in percentage of waste foundry sand. artificial sand with dust and natural sand”, International Journal of Earth (4) The Flexural strength is found to be marginally increase with increase in WFS content. (5) The problems of disposal and maintenance cost of land filling is reduced.

  • EXPERIMENTAL STUDY ON STRENGTH OF CONCRETE BY

    2017-9-23  dust for sand gives a high value of compressive strength than the conventional concrete. Also a 30% replacement of quarry dust for sand gives a high value of split tensile strength than the conventional concrete. It is also economical so sand can be partially (i.e. 30%) replaced by quarry dust.

  • Effect of Waste Foundry Sand (WFS) on the Mechanical ...

    2019-7-1  foundry sand. (3) Split tensile strength decrease on increase in percentage of waste foundry sand. artificial sand with dust and natural sand”, International Journal of Earth (4) The Flexural strength is found to be marginally increase with increase in WFS content. (5) The problems of disposal and maintenance cost of land filling is reduced.

  • A Technical Review on Quarry Dust and Foundry Sand

    2015-1-30  noticed fresh concrete behavior with foundry sand that workability is decreases with the increase of foundry sand content by slump test. Most of the researchers noticed positive changes in the concrete containing foundry sand and concrete containing quarry stone dust in terms of compressive strength and tensile strength.

  • EFFECT OF WASTE FOUNDRY SAND ON INDIRCT TENSIL

    The use of foundry sand in various construction engineering applications can solve many environmental problems. Foundry sand consists primarily of silica sand, coated with a thin film of burnt carbon, residual and dust. Foundry sand can be used in pavement to improve its strength and other durability factors.

  • use of recycled foundry sand in concrete

    Use of Recycled Foundry Sand in the Cleveland Area. the uses of recycled foundry sand in the Cleveland, Ohio area. The review was coordinated by Mr. Joe Alexander, Project Sales Manager, for Kurtz Bros. Kurtz Bros. is a materials broker that collects used foundry sand from various foundries and transports the material to projects where fill material is needed.

  • Characteristics of Concrete Containing Waste Foundry

    2016-9-1  chemical properties of concrete containing waste foundry sand as a partial replacement to natural sand. order to determine the influence of waste foundry sand on the behavior of concrete. From their study it was concluded that, control mix shows almost equal strength as that of the concrete

  • Synergistic Effect of Marble Powder and Green Sand

    位置: 8600 Rockville Pike, Bethesda, MD
  • aration of sand from cement by milling concrete

    aration of sand from cement by milling concrete. aration of sand from cement by milling concrete. 5 Repairs 9-17-14 (gjf) - Wisconsin Concrete Pavement Association ... Another "old rule of thumb" for mixing concrete is 1 cement : 2 sand : 3 gravel by volume. Mix the dry ingredients and slowly add water until the concrete is workable. Get Price.

  • Foundry Sand: Life of a Casting Reliance Foundry

    2020-2-14  Foundry sand is at the very center of sand casting. It can handle the heat of the molten metal, create a huge variety of shapes and details, and be reused again and again. Learn how foundry sand is made, used, and recycled.

  • Study on Cement Mortars Made with Coir Pith Particles

    2019-7-1  concrete incorporating quarry dust as a partial substitute for sand (9). Workability and strength behavior of concrete with cold bonded fly ash aggregate was studied (10). In the present study, sand is partially replaced by coir pith in mortar and analyzed. The

  • crushed sand used for conventional concrete manual

    Ball Mill. Ball mills are used primary for single stage fine grinding, regrinding, and as the second stage in two

  • Strength and Durabilitry of Fibre Reinforced Quarry Dust ...

    2016-1-5  Quarry dust has been identified as possible replacement for sharp sand in concrete works.Hence, quarry dust can be reasonably used as alternative to river sand. quarry rock dust does not contain silt or organic impurities and can be produced to meet desired gradation and fineness as per requirement. This consequently contributes to improve the

  • Characteristics of Concrete Containing Waste Foundry

    2016-9-1  chemical properties of concrete containing waste foundry sand as a partial replacement to natural sand. order to determine the influence of waste foundry sand on the behavior of concrete. From their study it was concluded that, control mix shows almost equal strength as that of the concrete

  • A Study on Self-Compacting Concrete by Replacing Fine ...

    2017-9-5  Dolomite powder. Foundry sand consists primarily of silica sand, burnt carbon, binder and dust. It can be used to improve the strength and durability properties of concrete. Foundry Sand can be used as a partial replacement of fine aggregates or total replacement of fine aggregate and as supplementary addition.

  • replacement of sand in concrete - cannabiskweken.be

    Some alternatives materials have already been used as a replacement of natural sand such as fly-ash, quarry dust or limestone and siliceous stone powder, filtered sand, copper slag are used in concrete and mortar mixtures as a partial or full replacement of natural sand (Chandana Sukesh et al 2013)[9].

  • Experiment On Light Weight Concrete Using Quarry

    Experiment On Light Weight Concrete Using Quarry Dust Fine Aggregate. We are a large-scale manufacturer specializing in producing various mining machines including different types of sand and gravel equipment, milling equipment, mineral processing equipment and building materials equipment.

  • artificial fine aggregate used in concrete ppt

    Lecture 5. Concrete - Aalto. Fine aggregate (sand): Sand consists of small angular or rounded grains of silica. Sand is commonly used as the fine aggregate in cement concrete. Both natural and artificial sands are used for this purpose. Functions of sand: 1. It fills the voids existing in the coarse aggregate. 2.

  • Study on Cement Mortars Made with Coir Pith Particles

    2019-7-1  concrete incorporating quarry dust as a partial substitute for sand (9). Workability and strength behavior of concrete with cold bonded fly ash aggregate was studied (10). In the present study, sand is partially replaced by coir pith in mortar and analyzed. The

  • Comparative Analysis on Partial Replacement of Cement

    2016-5-9  industry .Some alternative materials have already been used in place of natural river sand. For example, fly ash, slag and lime stone, siliceous stone powder, rock dust and quarry waste were used in concrete mixture as a partial replacement of natural sand. Hence the assumption is granite powder

  • Materials Free Full-Text Influence of

    In this work, magnesium oxychloride cement (MOC) was used to realize the resource use of foundry dust (FD). Portland cement (PC)-based superhydrophobic coating was prepared on the surface of FD/MOC composite to improve the water resistance of the composite. First, the FD/MOC composites with different contents of FD were prepared. The phase structure of the composite was analyzed using X-ray ...